Enable SPB-PIM Gateway on a VLAN

Enable SPB-PIM Gateway on a VLAN interface.

Procedure

  1. Enter VLAN Interface Configuration mode:

    enable

    configure terminal

    interface vlan <1–4059>

  2. Enable SPB-PIM Gateway on a VLAN:
    ip spb-pim-gw enable
    Note

    Note

    SPB-PIM Gateway cannot be enabled under the following circumstances:
    • If the IP interface does not exist on the VLAN. An IP Address must first be configured on the VLAN.

    • If the spbm_config_mode boot flag is set to false.

    • If the VLAN is configured with a circuitless IP.

    • If the interface is a management VLAN.

    • If ip igmp snooping is enabled.

    • If the spb-multicast is enabled on the VLAN.

    • If the VLAN has SMLT ports.

    • If the VLAN has an i-sid configured.

    • If the VLAN is a vIST VLAN.